Oven Repair
Built-in wall ovens and range ovens, single and double. Temperature drift, convection faults, sagging hinges, broken door glass, failed elements and igniters, and control lockouts after a cleaning cycle are the bulk of it, checked against a separate thermometer rather than the display.
The way it gets described
- Oven reporting it is up to temperature well before it is
- Convection fan noisy on the middle rack setting
- Door sitting proud of the frame and venting heat
- Controls locking out after a self-clean cycle
What the meter is put on
- Cavity temperature against the set point through a full preheat and a soak
- Sensor resistance at room temperature and again at heat
- Bake, broil and convection element continuity and visible condition
- Hinge tension, door seal and glass pack alignment
Flat $95 service call covering the visit and the diagnosis, credited against the repair if you approve it.
What people say afterwards
5.0
out of 5, from 1,254 reviews
★★★★★
The wall unit kept saying it was preheated when it was still a hundred degrees short, which explained a run of flat cakes. He put a probe in, found the sensor well out of tolerance, replaced it, then rechecked the reading at two different set points.
Nadine C. · Washington Square
★★★★★
The convection fan had a rattle on the middle rack setting that got worse with every bake. Loose blade nut and a worn bushing. Fixed on the spot, and he vacuumed the cavity out too.
Roberta M. · South Brookline
★★★★★
Controls locked out after a self clean and would not release. He said the thermal fuse had opened and the latch motor was tired. Both done in one visit and the door opens normally now.
Callum H. · South Brookline
Book the oven repair.
Model and serial number, a plain description of the fault, and whether the kitchen is up a stair or through a lobby. That is the whole call.
Answered 24/7 · on the road 8:00 am – 8:00 pm, seven days · flat $95 service call, credited against an approved repair
