A workshop, not a call centre.
This is an independent Viking service covering Brookline and the streets either side of it. It is not part of the manufacturer and does not present itself as one; what it is, is people who work on these appliances every week.
What we take on
- Viking cooking and refrigeration: ranges, wall ovens, built-in refrigerators and integrated dishwashers
- Gas work measured at the manifold, with pressure logged on every gas call
- Factory-approved parts specified against the model and serial number
- A flat $95 service call, credited in full against an approved repair
How the fault is found
Cooking and cold, one visit
A Brookline kitchen usually runs a Viking range next to Viking refrigeration, and the same call can cover both. Nobody is sent back a second time for the appliance standing beside the one that failed.
Buildings before appliances
Half of this work is access: shared lobbies, a lift that will not take a full-size range, a back stair with two turns. The route in is planned on the phone rather than discovered on the doorstep.
Numbers, then parts
Manifold pressure, flame-sense return, sensor resistance at heat, drain flow under load. A part is ordered when a reading says it has failed, not because it is the usual suspect.
The claims this page does not make.
No job count, no first-visit success rate and no trading history appear anywhere on this site, because none of them could be checked from outside and an unverifiable number is worth less than no number. What is checkable is here: the appliances, the flat $95 service call, the areas covered, and a phone line answered 24/7.
An appliance still inside the manufacturer's own cover should go to a provider the manufacturer has appointed. Everything else — out of cover, second-hand, inherited with the house — is exactly what this service exists for.
Start with a description.
Model and serial number, a plain description of the fault, and whether the kitchen is up a stair or through a lobby. That is the whole call.
Answered 24/7 · on the road 8:00 am – 8:00 pm, seven days · flat $95 service call, credited against an approved repair
What the repair itself costs
Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it. Ranges, not quotes — your figure is agreed before anything is taken apart.
- Igniter or burner assembly
- $270 – $630
- Oven thermostat or heating element
- $250 – $770
- Control board or touch panel
- $400 – $850
- Dishwasher pump or control
- $300 – $1,310
- Refrigeration fan or defrost system
- $310 – $730
- Compressor or sealed-system repair
- $1,060 – $2,630